Quote Originally Posted by Elitopus1 View Post
Usually when hooking up an L-pad the positive wire (signal in) goes to #1, the driver gets #2 wired to its postive terminal, and #3 goes to the negative side of the xover or speaker terminal.

2

In Jeff's drawing it looks like its only hooked up to two of the L-pad connections. I would contact him directly and ask how to hook it up. I have spoken with him before and he is very nice and helpful.

I am planning on building this same xover for my Urei 604G's. I am going to use a fixed resister in place of the L-pad. When I asked Jeff about this he said a 10 ohm resister is a good value to start at

Thanks for the response!

I contacted Jeff, and as you stated, only two of the pins are used. R4 goes to pin #2, and pin #3 goes to the mid point of R1 & R2.


I'll post photos when I'm done and give you my impressions. The supplies from PE is supposed to be delivered tomorrow!